I have seen them cut on One side, then wired in place.
From: Cliff Pike [SMTP:firstname.lastname@example.org]
Sent: Tuesday, December 01, 1998 8:27 PM
To: Triumphs List
Subject: Axle bumpers..
Thanks to all who responded with much appreciated advice to my previous
I have just received two new bump rubbers, which are slid over and
attached to the rear axle of the TR3A. Maybe I'm missing something, but
the only way I can see to install these is to remove the axle tubes from
the differential housing. My service manual gives no procedure for doing
this. Is this what I must do, and what is the best way?
'66 Spitfire4 MKII
.........Come visit us at http://www.mgl.ca/~cpike/home1.htm