Unisyn -issues solved thanks

["sujit roy" <sujitroy@hotmail.com>]

Thank you to all those who responded to my e-mail.
I set both needles to approximately the same height for both carbs and 
started from there.  The needle in the carb that caused the engine speed to 
increase when applying the Unisyn, was increased in increments of 1/4 turns 
to make a richer mixture.  As soon as the speed stopped increasing, with the 
Unisyn attached, I balanced the carbs.
The car now runs well.

Thanks Sujit
________________________________________________________________________