check out
http://www.caswellplating.com/pickabuff/start.htm
Paul Tegler ptegler@cablespeed.com
www.teglerizer.com
----- Original Message -----
From: "Scott Bloomer" <flaedersaft@juno.com>
To: <hamilton@ptd.net>
Cc: <triumphs@autox.team.net>
Sent: Friday, December 29, 2000 4:28 PM
Subject: Re: buffing compounds
>
> Ed,
>
> The compounds are applied to the spinning wheel by
pressing the
> hard stuff against the wheel. Not as easy as it sounds to
get
> the right dose.
>
> Scott
>
> On Fri, 29 Dec 2000 12:10:12 -0500 "Edward Hamilton"
<hamilton@ptd.net>
> writes:
> >
> > Silly question relative to a recently received set of
buffing wheels
> > and
> > compounds...The compounds are hard as a rock -- how do
you transfer
> > the
> > compound to the wheel.
> > Directions say to apply the compound to the spinning
wheel. This
> > simply
> > doesn't work. It the compound "warmed" first to
facilitate its'
> > flow?
> >
> > Regards,
> > Ed
|