Message text written by Scott Tilton
>I don't know if you are asking about PCing in general, but my question was
never how to heat the part. . . but how to make the powder stick since PC
uses electrical charge to accomplish this.
Scott, The electrostatic charge is only used to hold the powder to the
part until it is heated. Powder will stay on a horizontal surface without
the charge. And if you rub a piece of plastic on the car and build up a
charge on it the powder may well stick to it anyway.
I don't think that this is the show stopper. I think the heat issue is.
/// email@example.com mailing list
/// To unsubscribe send a plain text message to firstname.lastname@example.org
/// with nothing in it but
/// unsubscribe triumphs