Haven't tried this one yet, as I am using my firewall for ventilation,
however I would expect that if they are plastic/rubbery and you drop them in
boiling water for a minute or two, they might soften up enough.
Ed
-----Original Message-----
From: TM Windham [mailto:twindham@txucom.net]
Sent: Sunday, October 14, 2001 5:31 PM
To: triumphs@autox.team.net
Subject: TR6 Throttle Shaft
I removed my TR6 throttle shaft today in order to replace the bushings where
the shaft exits and enters the firewall and unfortunately I am having great
difficulty in getting the replacement bushings into the holes in the
firewall.
The replacement bushings are semi-rigid (from Moss) and although they will
bend somewhat I cannot seem to press (or beat) them into place. Has anyone
else experienced this? Any hot tips for getting these bushings pressed into
place would be appreciated.
Tom Windham
72 TR6
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
/// or try http://www.team.net/cgi-bin/majorcool
|