Hi,
I'm reassembling the sills on my TR4A. I've used a MiG to plugweld the
sills to each other, the front inner fender and the gussets at the
B-post. The old sills were attached to the bottoms of the A and B post
with brazing, which nicely smoothed the curve where the post joins with the
sill. I'm wondering if I can do this job with less than the full
oxy-acetelene rig, maybe one of those MAPP bottles. Never brazed anything
before, but I've used torches to solder copper pipes. I'd appreciate any
advice about equipment.
Thanks,
Cliff Hansen
hansenc@flash.net
1966 TR-4A CTC 64615L (one sill on and one sill off)
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
/// or try http://www.team.net/cgi-bin/majorcool
|