The stock engine shims on my GT6 were actually the same shims used under
the A-arm mounting brackets to adjust the suspension - They should be still
available, and what I used on all my motors (including the V6) to get the
correct engine angle -
***************************
>> BTW not only do you have to have the handle but you will likely have to
> shim the engine mounts to get the pawl nut to line up with the hole in
the
> radiator.
>As original. The shims are listed in the parts book, if they're missing on
>your car it's only because some previous mechanic left them out.
>I bought some fender washers and hacksawed slots (so I could slide them
>into place). May not be factory but sure is period.
Dave
Barry Schwartz (San Diego) bschwart@pacbell.net
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
/// or try http://www.team.net/cgi-bin/majorcool
|