I believe the ".005 oversize" washers are .005" for the pair. If you use
one paired with a standard, it will take up only .0025". That would put you
at .0055", which IMO is perfect.
As someone also noted, it's permissible to dress down the thrust washers a
bit, using very fine sandpaper and a sheet of glass or a surface plate.
> I just measured the crankshaft endplay on my TR6 at .008" with standard
> thrust washers. Bentley says .006" to .008". Haynes says .004" to .008". I
> have a set of .005" oversize washers. If I use one of these and one
> standard, I'll be at .003" endplay. One of the catlogs lists a .0025"
> oversize washer, but says no longer available. This would be ideal.
/// firstname.lastname@example.org mailing list
/// To unsubscribe send a plain text message to email@example.com
/// with nothing in it but
/// unsubscribe triumphs
/// or try http://www.team.net/cgi-bin/majorcool