| To: | MRobe33243@aol.com |
|---|---|
| Subject: | Re: crank seal choice/ now pump pin? |
| From: | CarlSereda@aol.com |
| Date: | Fri, 23 May 2003 19:37:58 EDT |
| Cc: | triumphs@autox.team.net |
In a message dated 05/23/03 4:23:34 PM, MRobe33243 writes: << If you pin it, I recommend a roll pin for a good fit. >> The factory used a solid pin so that oil doesn't go through middle of rotor. Carl '63 TR4 since '74 /// triumphs@autox.team.net mailing list /// or try http://www.team.net/cgi-bin/majorcool /// Archives at http://www.team.net/archive |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | RE: crankcase emissions, O2 meters, Randall Young |
|---|---|
| Next by Date: | oil pump priming, Mitchel Seff |
| Previous by Thread: | Re: crank seal choice/ now pump pin?, MRobe33243 |
| Next by Thread: | Re: crank seal choice/ now pump pin?, Dianne and Peter Fullam |
| Indexes: | [Date] [Thread] [Top] [All Lists] |