triumphs
[Top] [All Lists]

RE: TR-4 Rear Main Seal

To: "Randall" <tr3driver@comcast.net>
Subject: RE: TR-4 Rear Main Seal
Date: Tue, 3 Aug 2004 13:22:25 -0400
Cc: "Triumphs" <triumphs@autox.team.net> i73HMtt2015433
Message text written by "Randall"
>Definitely requires a special seal, which is split to allow it to fit over
the flange.  There is a coil spring that is assembled separately (the ends
hook together) and then put on the seal after the seal is installed on the
crank to hold the seal lips against the crank.  This is the spring that
Jack
Drews just advised trimming to 8" before installation, which sounds like
good advice to me.
<

Thanks for the enlightenment.  Since I haven't experienced this
modification, I didn't know.

Dave

Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8




<Prev in Thread] Current Thread [Next in Thread>