triumphs
[Top] [All Lists]

Chapter 3 on TR6 Transmission--Reverse gear grinder

To: <6pack@autox.team.net>, <triumphs@autox.team.net>
Subject: Chapter 3 on TR6 Transmission--Reverse gear grinder
Date: Thu, 12 Aug 2004 10:57:19 -0700
Cc: <rgperry@earthlink.net>, <sawblade@ptd.net>, <tr6_1969@hotmail.com>, <lang@isis.mit.edu>, <mjb@autox.team.net>, <jamdav@woodward.com>, <vance.navarrette@intel.com>, <red_tr250@yahoo.com>, <Gary.Oehrle@infineon.com>, <tr6taylor@webtv.net>, <Cristr6@aol.com>, <nariedel@adelphia.com>, <TTSCC@yahoogroups.com> i7CI6Ot2017044
Thread-index: AcR8SiZlKLtcJG6PQeCRwIhobgeiQgB3d/4gAJc8oNA=
Thread-topic: Chapter 3 on TR6 Transmission--Reverse gear grinder
to All

the transmission was pulled last night:

Clutch: Sachs type MF215   Koyo bearing
        
In short refer to Nelson Riedel article 
"TR250/TR6 Clutch Release Bearing Woes"
or "TR250/TR6 Reliable Clutch" since the 
clutch finger wear is identical to that pictured
there. In fact I would wager Murry Mercier and I 
have the same number of miles after the last
rebuild!!!

In addition, we noticed wear on the fork pins
(assuming they were round when install new 
several years back. The pilot bushing was a 
little wobbly and the throw out sleeve was  
a little wobbly on the transmission front cover.
(but not near as shown in the "Sticky Clutch" article.

No elongation in the slave fork but some in the 
master fork.  Bearing Fork was not cracked or broke but can
not say for sure if it was not bent.  Taper pin and 
cross bolt intact.

In summary nothing obvious and now thinking it is 
the summation of wear on the clutch fingers, master
fork etc. etc. etc. just like so many other TR6s!! 

at this point the plan is to start a rebuilding
1. clutch shaft and bushings
2. fork and taper pin  plus cross pin
3. transmission front cover, seal etc
4. the Throw-out bearing and sleeve
                Gunst--per Nelson Riedel's article
5. new clutch
                Sachs (assuming a still lower   
                        release force over Luk and B&B
6. new pilot bushing and rear engine seal.
                yep a little engine oil leaking
7. new fork on master plus rebuild it as well.  (hopefully someone
   sells just the fork!!

Comments, feedback and editorials are welcome


Also: I would appreciate any and all feedback about changing 
to the aluminum flywheels.


Thanks this far to: Chris Wehling for the help in the warm garage as it 
was 103F yesterday in Livermore CA and Nelson Riedel and his
articles on http://www.buckeyetriumphs.org/. And all those how have
provided there earlier comments and feedback.


Gary Oehrle

Watch for Chapter 4.  "Did the rebuild work!!!"

Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8




<Prev in Thread] Current Thread [Next in Thread>