triumphs
[Top] [All Lists]

The end (?) of More-- Operating shaft for Throwout bearing

To: <6pack@autox.team.net>, <triumphs@autox.team.net>
Subject: The end (?) of More-- Operating shaft for Throwout bearing
Date: Wed, 1 Sep 2004 12:54:08 -0700
Cc: <dmallin@attglobal.net>, <tr6taylor@webtv.net>, <vance.navarrette@intel.com>, <dcmdcm@earthlink.net>, <Gary.Oehrle@infineon.com> i81JvgdM023825
Thread-index: AcSQUUWkr7ptKhbnSQyDGl44iUdkKAABd5BgAADHZ6AAALJrQA==
Thread-topic: The end (?) of More-- Operating shaft for Throwout bearing
talked to Dave at TRF and he indicates the spring is not needed, he like
myself
can only guess why it is there and on some models of TR6 not there at
all.

case closed.

now to install it all and see if my problems are gone

        Ref:   TR6 Transmission--Reverse gear grinder

Gary Oehrle




-----Original Message-----
From Oehrle Gary (IFNA COM) 
Sent: Wednesday, September 01, 2004 12:32 PM
To: Oehrle Gary (IFNA COM); '6pack@autox.team.net';
'triumphs@autox.team.net'
Cc: 'Don Malling'; 'tr6taylor@webtv.net'; 'Navarrette, Vance'; 'Douglas
Morris'; 'Don Malling'
Subject: More-- Operating shaft for Throwout bearing


I know removing the spring is a quick fix and the real issue
is the placement of the fork by TRF on the shaft



Gary Oehrle
Office Phone 408-501-6896
Cell Phone 408-718-1175



-----Original Message-----
From Oehrle Gary (IFNA COM) 
Sent: Wednesday, September 01, 2004 12:30 PM
To: 6pack@autox.team.net; triumphs@autox.team.net
Cc: Don Malling; tr6taylor@webtv.net; Navarrette, Vance; Douglas Morris;
Don Malling; Oehrle Gary (IFNA COM)
Subject: Operating shaft for Throwout bearing



All
In the process of installing a new throwout bearing, cross shaft, etc
etc, I have run into the following problem; I am using the TRF RFK 1249
kit and when installed, the fork placement is such that the spring
between the housing and level is totally compressed and still the fork
is forced to the left such that the throwing bearing 
sleeve is very tight against the transmissions front end cover. I took
off the bearing/sleeve and measured between the fork pins and
transmission front end cover and found them to be different by ~1/16
inch. 

I recessed  the bushing  on the left and removed the spring and
reassembled. I can now move the bearing and sleeve on the trans front
end and even turn the sleeve.

Question: How necessary is the spring on the clutch operating shaft?
This gives me the necessary 1/16 inch (plus) for a smooth operation.  
 


Gary Oehrle

Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8




<Prev in Thread] Current Thread [Next in Thread>