> I have a PI TR6. The valve that allows you to set the idle
> on the manifold
> is loose. Is it suppose to be a tight fit, I guess so
> otherwise air will
> leak in all the time. Is it suppose to be bent? The nozzle
> bit that goes
> inside the manifold is on mine about 25 degrees. Is there
> any sort of O
> ring or does it just push into the manifold?
George,
It's supposed to be straight. It sounds like yours has taken a bit of a
knock. I just had a look at mine and it appears to be held in with some sort
of pin pressed into the throttle body. And it doesn't appear to have an
o-ring either.
HTH,
Frank Biedermann
69 TR6 PI
Adelaide, Australia
|