Re: TR6 front suspension on TR3

[Dave1massey@cs.com]

In a message dated 9/21/2005 3:22:37 PM Central Standard Time, 
vinttr4@geneseo.net writes: 
> To reverse the 
> process, and replace this spindle, could be done, I suppose, but it 
> would be exceedingly difficult. To get them in the right place, right 
> length, etc will take more than a simple welding job.

Since there is no adjustment they better be pretty close because your stuck 
with the results.  At least with the 4A-6 brackets you can adjust out the 
inaccuracies from welding.

Dave