I have a fiberglass gearbox tunnel (which doesn't fit worth a damn)
which doesn't seem to seal properly. The PO replaced the pax side floor
board but it didn't have a cutout for the handbrake. I cut a hole in
the floor, but something doesn't seem right. The gbx cover has a flat
area into which the h'brake grommet is apparently intended to fit.
However, if I cut the gbx cover, it'll leave an open area for water, etc
to pool on the floorboard inside the grommet. And that makes no sense.
64 TR4 in autox preparation
95% finished, 90% to go
This list supported in part by the Vintage Triumph Register
Triumphs mailing list