--===============1777588917==
Content-Type: text/plain; charset="windows-1250"
Content-Transfer-Encoding: 7bit
John,
Someone else had this issue just a few weeks ago, maybe can make some
experienced suggestions.
Best case, it is just water that got in the channel and is boiling off.
Worst case, cracked block.
If it does not boil off I would try some sealant on the bottom threads of
the stud.
Could be a small disfigurement in the head gasket or some bits of debris.
If all looks good, loosen and re-torque everything.
Bill B
'58 TR-3A TS/30766 L
"I love it, she hates it... the car, of course!"
-----Original Message-----
From: triumphs-bounces+wbeech=flash.net@autox.team.net
[mailto:triumphs-bounces+wbeech=flash.net@autox.team.net] On Behalf Of John
Gillis
Sent: Monday, November 19, 2007 3:39 PM
To: Triumph List
Subject: [TR] water at stud??
Hi all,
running my TR2 engine again, for about 15mins this time, and having a good
look round. I noticed bubbles of water rising up from between the nut and
the thread of the centre head stud on the manifold side. A cause for concern
or no?
Regards
John
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
http://www.team.net/donate.html
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
No virus found in this incoming message.
Version: 7.5.503 / Virus Database: 269.16.1/1140 - Release Date: 11/19/2007
7:05 PM
Version: 7.5.503 / Virus Database: 269.16.1/1140 - Release Date: 11/19/2007
7:05 PM
--===============1777588917==
Content-Type: text/plain; charset="us-ascii"
MIME-Version: 1.0
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
http://www.team.net/donate.html
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
--===============1777588917==--
|