Certainly worth rebuilding a priming lever pump.
This is just my opinion, but if the valves are working okay I leave them
alone. I have never had a valve fail but I have had a replaced valve fall
out.
Okay, it wasn't properly staked if it fell out -- but I just tend to not
mess with what can be a fussy task if the original staking is sound and the
valves test fine with my suck & blow method.
Geo Hahn
----- Original Message -----
From: "Roger Elliott" <elliottr@rmi.net>
To: <triumphs@autox.team.net>
Sent: Friday, December 07, 2007 6:09 PM
Subject: [TR] Fuel Pump rebuild
>I have an original fuel pump with the priming lever that I would like to
> rebuild. I have purchased a rebuild kit. One of the valves I can get
> to from the back with a punch, but not the other one.
>
> Does any one have a good trick for getting the valve out? Any other
> tips for rebuilding it?
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|