On Monday 03 March 2008 06:58 am, DLylis@aol.com wrote:
> A PO of my 3A brazed a few small mild steel patches that are acceptable.
> I need to do some metal fill at the edge of one of the patches and am
> hesitant to braze as I am afraid that the heat will cause the existing
> braze to let go. Does anyone know if tin/copper lead free solder on a
> roll (plumbing) with no flux core is the same that is sold as lead free
> body solder? I don't need much so I am not too excited about buying body
> solder.
> Body filller is not an acceptable soluton as there are pin holes that need
> to be filled and I do not like to fill holes with filler.
>
> David Lylis
> 69 TR6 CC26160L
> 60 TR3A TS74461LO
>
David,
Here is a link to eastwood's product.
http://www.eastwoodco.com/shopping/product/detailmain.jsp?itemID=14770&itemType=PRODUCT&iProductID=14770
I went with the lead/tin product with great results. This wasnt available a
few years ago.
THey have a whole line of body solder stuff.
Bob
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|