Bob,
I bought mine (for my 4a) from British Parts Norhtwest. Great price and well
made. I had to use clamps and a lot of strength to get them in, but the end
result is a great fit and tight steering. I'd recommend checking out BPNW.
BTW - make sure to change the column bushings too!
Brian
'67 4a
------------------------------
Message: 2
Date: Sun, 9 Mar 2008 14:38:03 -0400
From: "Bob Rochlin" <r_rochlin@hotmail.com>
Subject: [TR] Rubber steering coupling
To: "Triumphs" <triumphs@autox.team.net>
Message-ID: <BAY117-DAV65B4478EF9AACA2C963E19F0D0@phx.gbl>
Content-Type: text/plain; charset="iso-8859-1"
Hi Everyone,
Im trying to fit a new rubber coupling to the steering shaft of
my TR6. There are two problems. One is that the replacement from TRF is
counter sunk for cap bolts on both sides of the coupling instead of one as
original, and the second is that the holes line up as about < inch too far
apart. Has any one else had this difficulty, and does any one know a source
for this part that is made accurately?
I knew things were going too smoothly
Bob Rochlin
72 TR6
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|