Thanks to the list I have been working on my front wheel run out beginning at
the hubs. Once I believe I saw a comment here that you could place the front
grease seal in the hub and then tighten the hub on the spindle to seat it.
My experience was that the grease seal will not completely seat using this
method. If it does not completely seat it produces run out at the hub. You
need to seat it with a wood block and hammer making sure the lip of the seal
has a uniform level at the back of the hub.
After turning the mounting face of the hubs I now have a run out of 0.003 on
each side. That is down from 0.026 on one side.
> From: email@example.com
> To: firstname.lastname@example.org; email@example.com
> Date: Sun, 9 Mar 2008 14:28:44 +0000
> Subject: Re: [TR] set available, NA individual
> The last time I ordered a brake line from Moss they sent me a piece of
> refrigerator line. Use TRF, their lines are steel and pre-bent to original
> Best regards,
> Need to know the score, the latest news, or you need your Hotmail.-get your
> Support Team.Net http://www.team.net/donate.html
> This list supported in part by the Vintage Triumph Register
> You are subscribed as firstname.lastname@example.org
Climb to the top of the charts! Play the word scramble challenge with star
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register