triumphs
[Top] [All Lists]

Re: [TR] heater control cable -TR6

To: <triumphs@autox.team.net>
Subject: Re: [TR] heater control cable -TR6
From: "Randall" <tr3driver@ca.rr.com>
Date: Mon, 3 Nov 2008 11:43:18 -0800
> Heater control cable hardly moves center wire at heat control valve.
> Dashboard end moves properly, so it seems the outer sheath has come  loose
> on control side. Is there something that comes loose and can be tightened
> or
> is this the way these cables usually fail? 

Bob, in my very limited experience, what happens first is that the valve
itself gets hard to move.  Then the center wire buckles right at the
dashboard lever, producing the condition you describe.  The temporary cure
appears to be to replace both the valve and the cable.

The permanent cure appears to be to re-engineer the thing using a different
valve.  Although I have not tried it, I suspect you could leave the original
valve in place (open) and a dummy length of operating cable through the
firewall; then rig the interior lever to operate a Chrysler-style valve
hidden inside the passenger compartment.  But it's just a thought since I
don't own a TR6.

Randall
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>