triumphs
[Top] [All Lists]

Re: [TR] Ammeters and Voltmeters

To: "'TR List'" <triumphs@autox.team.net>
Subject: Re: [TR] Ammeters and Voltmeters
From: "Randall" <tr3driver@ca.rr.com>
Date: Fri, 7 Nov 2008 21:59:13 -0800
> In view of all the recent discussions on these meters, I was 
> wondering if it's difficult, or requires a lot of electrical 
> expertise to convert from a voltmeter (as in a TR6) to an ammeter?

It's not trivial, but not terribly difficult either.  Basically you have to
divide the electrical system into the battery and starter on one side (plus
perhaps the horns and the sense wire to the alternator), and everything else
on the other side; then connect the ammeter between them.  

Assuming this is a 73 or later TR6 (earlier cars had ammeters), you can just
remove 3 of the 4 brown wires that go to the tie point in the battery cable;
join them together somehow (perhaps with one of these:
http://www.madelectrical.com/catalog/cn-1.shtml ) then run a pair of heavy
wires (10 AWG will do, but I'd use 8) from the old tie point and the new tie
point to the ammeter.

Randall
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>