Hi group,
I read the description of Ken's alternate method to the Churchill hub
pulling tool. It makes sense if you look at a cross sectional view of the
rear hub. The drawing I used was on page 390 of the Bentley "The Complete
Official Triumph TR6 & TR250 1967-1976" manual.
Before I dig out one of my spare hubs, does anyone know offhand what size
the axle nut threads are and what bore size is in the hub portion?
Greg Gelhar
1973 TR6
1980 TR8
Osseo, MN
>> Or, Ken describes an intriguing alternative here
> > http://192.94.170.51/start/phorum/read.php?1,15880,15982#msg-15982
> > that might be worth a try. Haven't had occasion to try it myself yet,
> but I
> > will when the time comes.
> >
> > Randall
>
>
>
> Randall,
> Did you ever receive the pictures to which he refers? I would like to
> include this in my library of "When the time comes".
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|