Do you know what type fittings it has?
I have a different mc than the original (it's County brand), but, I lost
the adapters it uses for this particular mc line.
----- Original Message -----
From: "Bob" <firstname.lastname@example.org>
Sent: Tuesday, May 05, 2009 9:42 PM
Subject: [TR] thickness of clutch mc to slave line?
>I recently used the stock pipe piece from TRF PN 148816.
> It required minimal reshaping and worked just fine.
>> On May 5, 2009, at 5:44 AM, dorpaul wrote:
>> > Hi,
>> > Is it correct to use the same size tubing
>> > between the Clutch MC and it's slave cylinder
>> > as that of the brake line (I think that's 1/8" tubing, right?).
>> > Is there any benefit to using a larger diameter tubing for this
>> > line? If so,
>> > I'll need to obtain fittings for the larger tube (from where?).
>> > Thanks, Paul Dorsey
>> > _____
> E-mail message checked by Spyware Doctor (188.8.131.526)
> Database version: 5.12320
> Support Team.Net http://www.team.net/donate.html
> This list supported in part by the Vintage Triumph Register
> You are subscribed as email@example.com
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register