In a message dated 10/21/2009 11:20:40 AM Central Daylight Time,
> I've tested the valve by sucking and blowing in the bottom of the valve
> goes to the intake manifold. It doesn't allow gas to go back into the
> cover, but when I suck it allow air into the manifold, even when I push
> on the disk and post gadget inside the valve that
> sits directly and vertically over the check valve. Shouldn't doing this
> prevent air from going into the intake? Is there a way to fix this? It
> looks like the valve part is pressed into the housing.
Check the diaghram. I had one split on my MGB years ago and fixing it did
a world of good.
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register