triumphs
[Top] [All Lists]

Re: [TR] Aftermarket TR3 Heater Install

To: William Brewer <wsb1960tr3a@att.net>
Subject: Re: [TR] Aftermarket TR3 Heater Install
From: Michael Lang <mlang99@comcast.net>
Date: Sat, 14 Nov 2009 18:35:47 -0800
Bill,

Thanks for the detailed description. It sounds like a relatively low
cost way to retrofit a good heater.

Mike

William Brewer wrote:
>      Several people have inquired about my TR3 aftermarket heater install,
so here it is.     I bought the heater from
http://www.sportsimportsltd.com/12-volt-maradyne-cab-heater-12-500-btu.html
for $139.95.     To install, I had to shorten the tubes out the back. I
shortened them to be about even with the outside case. I also had to move my
OD relay from the behind the back of the battery box to the side to get
clearance. You have to reduce the 1/2" copper outlets to match the diameter of
the TR3 heater hoses. Use a 1/2" to 3/8" copper reducers (I got mine at
Lowe's) and either use a 3/8 copper pipe or a 1/2" by
>  .014 brass tube like I bought at a True Value hardware store. I put in 90
degree elbows immediately behind the heater, then a short length of 1/2"
copper pipe and then reduced
>  it down after the edge of the sides to allow access to the hoses. I made
sheet metal 90 degree brackets to bolt it all to the dash braces.     The
thing blows like a blast furnace and I love it. I had had it with monkeying
around with the original pathetic fog stirrer heater. BTW, HVDA has the same
heater in his TR3, if that tells you something.     I am still making fittings
for the defroster hoses. There are precut and blanked off holes on each side.
I have to reduce them to the defroster hose size.     Instead of soldering
everything, if I were to do it again I think that I would use marine epoxy
that you can buy at an ACE hardware or marine supply. I used it for high temp
fittings in a vegetable oil fuel system in my Mercedes and it never failed me.
Soldering close to the heater core and metal case is questionable and nerve
wracking.     Other things I like (besides being warm) are that with the
heater low like it is I can easily get
>  behind the
>  dash if I need to get to gauges or light bulbs and things. My car has a
black interior and the black heater just sort of blends in with the carpet.
I had
>  to mount it low, below the dash to clear the choke cable. I could have
mounted it high, above the cable, but then it would have been hard to open the
vents. It would have fit and been out of sight.     The original rheostat
works with the new heater.     Total cost of the conversion was probably about
$150. I reused the original heater hoses.     Bring on the cold.
>      Bill in Tehachapi

_______________________________________________

Support Team.Net  http://www.team.net/donate.html

This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>