Another way of guarding against hinge breaking along with correct side is
double check the angle on the "BOTTOM" of the complete hinge, it will have a
angle for the curvature of the hood or deck lide, thus left on the right
will not work FT
===========================================================================================================
----- Original Message -----
From: "Randall" <tr3driver@ca.rr.com>
To: <triumphs@autox.team.net>
Sent: Thursday, November 19, 2009 2:20 PM
Subject: Re: [TR] boot/bonett hinges
> Left and right are not too hard to tell : If you look at the space below
> the
> hinge pin on each side, I think you'll see that one side is longer than
> the
> other. The long side always goes to the outside of the car. Getting this
> wrong is a sure way to break the hinges!
>
> There is supposed to be a difference in stud location between boot &
> bonnet
> hinges, but I don't recall for sure which one is which offhand. Only one
> of
> the smaller studs is different; if memory serves the small stud near the
> hinge pin is farther away from the pin on the bonnet hinges.
>
> Some of the boot hinges also have a round brass rivet sticking up that
> serves as a stop; but I've seen lots of repro boot hinges without it, and
> even some bonnet hinges with it.
>
> -- Randall
>
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> This list supported in part by the Vintage Triumph Register
> http://www.vtr.org
>
>
> Triumphs@autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs
>
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|