I am finally getting around to installing the vinyl trim on the rear
wheel arches in my TR3A. Are there any specific tricks to getting it to go
smoothly and without wrinkles? I have some 3M trim adhesive in a spray can
that I plan on using. I was going to locate the trim panel at the beading and
glue that down first. Then I was going to use a hair dryer to keep it all
pliable and work the inside wheel arch down first, followed my the top of the
It looks like getting the beading part part down flat without wrinkles is
the tough part.
Any advice would be appreciated.
Bill in Tehachapi
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register