triumphs
[Top] [All Lists]

[TR] Tranny Story 2

To: Triumphs@autox.team.net.Spit
Subject: [TR] Tranny Story 2
From: "Jim Muller" <jimmuller@rcn.com>
Date: Thu, 21 Oct 2010 18:01:39 -0400
I got some parts back from my local machine shop today.  The main 
task I wanted was a hardened sleeve put on the roller bearing surface 
where mainshaft fits into the input shaft.  They did a good job 
except for one thing.

The OD is now too big.  It won't fit into the input shaft's hole with 
the bearing in place.  Bummer.  I'll take it back but with the shaft 
turned down to accept the sleeve I don't know what the original 
diameter was.  I would have thought they'd have measured that and 
replicated it precisely.

If any of you know that spec I'd be glad to hear it so I can go back 
to the shop prepared.

I am not a happy camper at the moment.  Not too worried, but these 
things aer always better off resolved than pending, if you know what 
I mean.

Jim Muller
jimmuller@rcn.com
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>
  • [TR] Tranny Story 2, Jim Muller <=