triumphs
[Top] [All Lists]

[TR] TR4A badge bar

Subject: [TR] TR4A badge bar
From: yellowtr at adelphia.net (Bob)
Date: Sat, 2 Apr 2011 09:44:31 -0400
References: <EDC8BD6755BF405493B992536081F123@I7Quad>
On Saturday, April 02, 2011 09:03:00 am spamiam at comcast.net wrote:
> I am thinking of adding driving lights to my TR4A.  Due to the hood tipping
> forward, clearance is a real issue.  Positioning needs to be pretty tight
> to the grille so they won?t interfere with the hood.
> 
> I have not seen any commercial badge bars to which I might mount the
> lights.  Since the lights are heavier than badges, the bar would need to
> be pretty stable, too.  I saw that Moss sells clamps for stem-mount lights
> and the clamps fit a 3/4? diameter bar.  So, I am looking for a 3/4?
> diameter bar.
> 
> Any suggestions?
> 
> Alternatively, I might be able to fabricate my own bar and custom arms
> which would piggyback to the bumper mounts.  I see that 3/4? 304 stainless
> 16 gauge tube stock is not terribly expensive.  That would be a
> possibility, but I did not find any end caps that would be suitable.  Any
> suggestions on this approach?  Source for end caps that do not rely on a
> pipe thread?
> 
> -Tony
Tony,

I was in the same boat with my 63 4. I tried to get the bar to attach between 
the two over-riders but the bonnet would hit the bar when opened.

So I decided to fabricate a set of mounts that allowed me to install a 3/4 
inch chrome bar between the over-riders. The mounts attach to the license 
plate holes in the front and are made of 1/4 " bar steel and I had to add a 
set of mounts that act as a clamp to the rear to add stability. I made them so 
when I tightened them to the front bar mount they would clamp to the top rear 
of the bumper. 

In order to prevent scraping and scratching of the bumper I sprayed some of 
that plastic tool prep called "Plastic Dip" on the insides.

If you want a photo or 2 let me know.

The badge bar supports a fog and driving lamp plus the autox badge.

Bob

<Prev in Thread] Current Thread [Next in Thread>