triumphs
[Top] [All Lists]

[TR] Head Off e.tcd.ie>

Subject: [TR] Head Off e.tcd.ie>
From: tony at tonydrews.com (Tony Drews)
Date: Sat, 23 Apr 2011 16:19:15 -0500
References: <F3ADC4F5824AE54A8F71B0D3D55F91FB031A2073C930@GOMAIL.college.tcd.ie>
You should be able to pull the head without disturbing the figure 8 
seals.  I normally stack a couple of sockets on the head studs and 
put a nut on top to hold the liners in place with the head off, 
though.  That way if you turn the engine over the liners don't move 
with the pistons.

I'm a source of the thick compressible high temp graphite intake / 
exhaust gaskets, but only have them for the high port head.

Tony Drews

At 11:55 AM 4/23/2011, John Gillis wrote:
>Hi all- engine removed finally to deal with my cam shaft core plug 
>that dropped out fooling me into thinking the rear crank seal was 
>the culprit. Anyway you may remember I had problems getting smooth 
>running, which seemed like a vacuum problem. I thought I might take 
>the head off and have a look inside. Can I safely take the head off 
>without disturbing the liners and their figure of 8 seals? Also if I 
>have a problem sealing around the inlet manifold, are the new 
>thicker gaskets I read about on the list available for the low port 
>head and if so from who?
>Regards
>John
>
>
>John Gillis
>Senior Conservator
>_______________________________________________
>Triumphs at autox.team.net
>Donate: http://www.team.net/donate.html
>Suggested annual donation  $11.47
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>Manage your account: 
>http://autox.team.net/mailman/options/triumphs/tony at tonydrews.com



<Prev in Thread] Current Thread [Next in Thread>
  • [TR] Head Off e.tcd.ie>, Tony Drews <=