triumphs
[Top] [All Lists]

[TR] TR3 Windshield

Subject: [TR] TR3 Windshield
From: auprichard at uprichard.net (Andrew Uprichard)
Date: Thu, 1 Sep 2011 19:46:08 -0400
References: <4E600A2C.8040308@frontiernet.net>
I found three pieces of advice particularly valuable:

1.  Glue the rubber piece to the glass.
2.  Trim the rubber where it has to be folded around the corners.  
3.  Use plenty of soap

It is a difficult job at best, but made easier when you follow these
guidelines.

Andrew Uprichard

-----Original Message-----
From: triumphs-bounces at autox.team.net
[mailto:triumphs-bounces at autox.team.net] On Behalf Of George Richardson
Sent: Thursday, September 01, 2011 6:42 PM
To: triumphs at autox.team.net
Subject: [TR] TR3 Windshield

Way back, when I first restored Squirtle the TR3, I replaced the 
windshield. What was provided then was some rubber channel thing that 
could never get into place, so I just used regular windshield sealer. 
That worked fine, maybe too fine, since I have problems getting it out 
when (purely for stupid reasons well withing my control) I smashed my 
windshield.

I ordered a seal from TRF along with a bunch of other stuff, but what 
cam this time is a flat rubber piece that I guess wraps around the edge 
of the windshield glass. Anyone use this? Any advice? Should I just 
stick with my windshield sealer?

-- 
George Richardson


triumphs at autox.team.net

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/auprichard at uprichard.net

<Prev in Thread] Current Thread [Next in Thread>