triumphs
[Top] [All Lists]

[TR] Soldering

Subject: [TR] Soldering
From: dkspence at telus.net (don spence)
Date: Sun, 4 Mar 2012 13:56:05 -0700
References: <mailman.647.1330884761.1938.triumphs@autox.team.net>
 1: use an electrical solder such as KESTER 44 resin core.
2: Use a rosin paste flux

An iron with some mass ( hot the huge one you use to solder rain gutters)is
better than a gun.

To do bullets, get a solid piece of wood and drill holes slightly larger in
diameter and shorter in depth than the bullet.

Prepare the end of the wire by stripping the insulation. Put the wire in a
vice or clamp so you have two hands to work with.
Next you "tin" the wire.
Apply some flux to the wire and melt a bit of solder on the face of the iron.
(use a wedge tip).
Apply the iron to the wire. When  the wire is hot enough the solder will flow
into the multistrand. Add solsder as necessary to fill the end of the wire.


Now turn your attention to the bullet.
Put the bullet in the hole and put a small quantity of flux in it.
Apply the iron to the side of the bullet (with flux in it). As it heats up
feed the solder strand into the bullet so it melts and fills the cup. While it
is still molten, place the tinned wire into the bullet. Keep the iron on it
until the solder in the wire melts then remove the iron and let it cool to a
solid joint.

Easy peasy.


On 2012-03-04, at 11:12 AM, triumphs-request at autox.team.net wrote:

> From: Dave1massey at cs.com
> To: triumphs at autox.team.net
> Subject: Re: [TR] soldering
> Message-ID: <3d9c7.41ec44ee.3c84e8e6 at cs.com>
> Content-Type: text/plain; charset="us-ascii"
>
> In a message dated 3/3/2012 10:00:42 PM Central Standard Time,
> nafzigerg at yahoo.com writes:
>> Do I need a larger soldering iron or do I need
>> different solder?  Is there a solder specifically for electrical
>> connections
>> in cars that has a lower melting point?
>>
>
> You have received a couple of well informed replies already but let me add
> my technique to the list.
>
> The secret to soldering is to get the parts hot enough to melt the solder.
> I apply a small ammount of solder to the tip of the soldering gun/iron as
> this will greatly improve heat transfer.  Then I heat the bullet since this
> is the largets mass.  I then apply the solder to the bullet.  When it gets
> hot enough the solder will begin to melt and I feed the solder in to make
the
> joint.  With that ammount of heat and the bullet hot enough the wire will
> quickly heat up enough to take up the solder and the joint will be a solid
> one.
>
> I just made a dozen or so of these joints last weekend on my TR3 and the
> biggest problem I had was caffine related.  Trying to hold the soldering
gun
> sdeady for the 30 seconds or so on a bullet ballanced precariously on the
end
> of a small, wavering wire while trying to apply solder with the other
> required much concentration for this old man.
>
> It ain't easy and I have quite a bit of experience in electrical soldering.
>
> Dave

<Prev in Thread] Current Thread [Next in Thread>