Working on the assumption that a wheel hump is a wheel hump is a wheel
hump.............. here's how it's done on a TR6.
http://www.victoriabritish.com/interiors/T6/wheel-arch-cover-installation.htm
They use a spray adhesive like 3M 77 but only glue the edges which is the
easiest way to install them.
Being dumb, or maybe a risk taker............ I did it this way
http://tr6.danielsonfamily.org/InteriorPanelInstall1.htm and it came out
real good.
Bob
Bob Danielson
http://tr6.danielsonfamily.org
1975 TR6 with:
Throttle Body Injection
Toyota 5 Speed
Nissan Diff & CVJs
-----Original Message-----
From: Joe DeMuth
Sent: Sunday, March 11, 2012 1:43 PM
To: triumphs at autox.team.net
Subject: [TR] Installing TR3 Interior
I am installing a new interior on aTR3. The panels are pretty straight
forward, but no so with the rear wheel arches. The kit I bought has
some synthetic horse-hair like padding that appears to be cut in a
shape that suggests its use over the top and sides of the arches. Any
suggestions or hints as to how this goes together? In particular,
should I be using contact cement or spray adhesive to affix the pad to
the arch, and what about the vinyl to the padding? Also, how thick
should the padding be, (the stuff I have is about an inch thick) and
how compressed by the top covering?
** triumphs at autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/75tr6 at tr6.danielsonfamily.org
|