stainless steel sheet metal screw. know as an "AB" point here in the USA.
if
the post is not pre drilled use a #29 drill (0.136") or try a 1/8" drill. lead
post is quite soft so you may be OK with the smaller dia drill.
From: John
Macartney <flywheelcoventry1 at yahoo.co.uk>
To: "wbeech at flash.net"
<wbeech at flash.net>; "triumphs at autox.team.net" <triumphs at
autox.team.net>
Sent:
Thursday, March 22, 2012 10:28 AM
Subject: Re: [TR] Lucas Batt Cap screws
The
factory used a simple cheese head drive screw - about a #8 1/2" Battery
posts
were already pre-drilled (as were all of them in Europe) 30+ years ago.
Jonmac
________________________________
From: "wbeech at flash.net"
<wbeech at flash.net>
To: triumphs at autox.team.net
Sent: Thursday, 22 March 2012,
17:06
Subject: [TR] Lucas Batt Cap screws
>Got the battery cable soldered
into those helmet-type Lucas post connectors.
>
>
>Now, what is the correct
type/size of screw to secure the cap to the post?
>Looks like a stainless wood
or sheet metal screw might do the job as I am
>not sure a machine thread would
hold in the lead post.
>
>Thanks,
>Bill
>
>** triumphs at autox.team.net **
>
>Donate: http://www.team.net/donate.html
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/flywheelcoventry1 at yahoo.co.uk
** triumphs at autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/yellowtr3 at yahoo.com
|