Re: [TR] TR2/3 carb issue - fiber washers

[Frank Fisher <yellowtr3@yahoo.com>]

i put a thin film of Hylomar on mine.
i did it first time and no leaks. so i cant say if it was the Hylomar or just 
good gasket fit
Frank
 

________________________________
 From: Angelo Graham <agraham@execulink.com>
To: triumphs@autox.team.net 
Sent: Wednesday, August 1, 2012 7:42 AM
Subject: [TR] TR2/3 carb issue - fiber washers
  
Hello List:
I fitted SU carb kits to my H4 carbs and was very pleased with the quality of 
the SU kits and the components supplied. Managed to get all of the leaks 
stopped and the float/needle issues straightened out. Only one problem, I can't 
manage to get the rear float bowl attachment point to stop leaking. The front 
carb float bowl with the supplied fiber washers is fine - no leaks, but the 
rear is another matter.
I dressed the mating surfaces with a file, doubled up on the fiber washers, bu 
no luck. Still a prominent leak. I have used new fiber washers each time, but 
still no luck.
Any substitute for the fiber washers? Something in a softer, more compliant 
material to affect a better seal against the bowl/carb body? What about using 
something like Permatex on the washers?
Any advice greatly appreciated.
Thanks,
Angelo Graham

** triumphs@autox.team.net **

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage: 
http://autox.team.net/mailman/options/triumphs/yellowtr3@yahoo.com

** triumphs@autox.team.net **

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage: 
http://autox.team.net/mailman/options/triumphs/triumphs-archive@autox.team.net