Re: [TR] TR3 Door Seals

["Wbeech" <wbeech@flash.net>]

The fuzzy seal goes up the side of the "A" pillar and "B" pillar.  On the
"B" you have that stuff that looks like someone rolled up a brown paper bag
real tight and stuck it into that slotted gap, tack your fuzzy strip to that
and then the interior panel will cover it.  On the "A" pillar I just glued
it on that edge then when it got covered with the panel I made sure I caught
it with three screws, top, bottom & center.

The clips go into those holes along the bottom of the door and along the
bottom of the front scuttle, where it meets the door, then it wraps up under
the front dash rail capping, about three inches.  You clip the clip onto the
rubber then push/pull it through the hole.  I did mine while the door panel
was off and used a pair of 90 degree needle-nosed pliers to grab it and pull
it on through the hole and lock into place.

Picture available upon request.


Hope this helps,
Bill



-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of terryrs@comcast.net
Sent: Saturday, September 15, 2012 4:51 PM
To: triumphs@autox.team.net
Subject: [TR] TR3 Door Seals

Dear me.

I've received my rubber door seals and clips, including a length of seal
covered with red material to match my interior.

I do not, however, have a clue how to install.

Anyone have an idea where an instructional video or solid prose instructions
might be had?

Thank you all.

Terry Smith, 1959 TR3A
New Hampshire

** triumphs@autox.team.net **

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/wbeech@flash.net

** triumphs@autox.team.net **

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage: 
http://autox.team.net/mailman/options/triumphs/triumphs-archive@autox.team.net