| To: | "G.D. Huggins" <guy@genfiniti.com> |
|---|---|
| Subject: | Re: [TR] TR4 front end bacing |
| From: | Anthony Cascio <allegrorover@mac.com> |
| Date: | Tue, 29 Jan 2013 14:49:34 -0500 |
| Cc: | "triumphs-request@autox.team.net car discussion" <triumphs@autox.team.net> |
| Delivered-to: | mharc@autox.team.net |
| Delivered-to: | triumphs@autox.team.net |
| References: | <49B6820F-61C5-453D-8303-E22948FBD57E@mac.com> <66F348FA-C15F-4AC7-BA77-833BF7723F5E@genfiniti.com> |
Sorry, it's a TR4A on a solid axle frame. And I believe it's the bracing setup for the lower A arms where they attach to the frame. Evidently they were not welded as good as they could have and the single bolt where the new kits have a two bolt set up. I just wondered if anyone had done this already and if there were any photos available before I attempt this upgrade. Thanks Tony Cascio ** triumphs@autox.team.net ** Archive: http://www.team.net/archive |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TR] TR4 front end bacing, G.D. Huggins |
|---|---|
| Next by Date: | Re: [TR] TR4 front end bacing, Darrell Walker |
| Previous by Thread: | Re: [TR] TR4 front end bacing, G.D. Huggins |
| Next by Thread: | Re: [TR] TR4 front end bacing, Darrell Walker |
| Indexes: | [Date] [Thread] [Top] [All Lists] |