> Is there a way to set up grease caps so you can get them off
> easier for next
> time? I was thinking of drilling a hole through the center
> and mig welding a
> nut on the outside so I could thread a bolt through and push
> against the stub
> axle to push it off.
There should already be a 10-32 hole for that. But I find that the threads
are usually not strong enough, so I epoxy a nut inside the cap. (ISTR that
was originally a tip from Geo Hahn)
Or you could probably find a cap at FLAPS with the rolled edge so you can
pry it off.
Randall
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|