Hello,
Is there some reason you dont want to leave the plastic on? I put tape
on mine before install to insure no scratches on the paint.
Bob
On 09/09/2014 03:27 PM, Wbeech@flash.net wrote:
> I have a set of the same beading from TRF, not yet installed. Better go check
> it out. If anyone has the solution please post it to the full list.
>
> Bill
>
> Sent from mobile Bill
>
> On Sep 9, 2014, at 1:43 PM, tom white <tswhitez123@hotmail.com> wrote:
>
> Hi List,
>
> I bought a wing bead kit from TRF for my 1960 TR3A. Today I unpacked one to
> install on a rear fender. The beads have all been covered with a black
> plastic protective coating. No problem just peel and strip, WRONG AND
> IMPOSSIBLE.
>
> I called TRF and their suggestion was use a hair dryer of low setting on my
> heat gun to strip the plastic, WRONG AGAIN. I did manage to get the plastic
> off of one small rear fender tail bead with ten minutes of high heat from the
> heat gun. The same approach did not proof effective on the larger rear
> fender
> bead. I also attempted to remove the plastic with buffing and nylon brush
> wheels on my Dremel. The Dremel proved useless too. I tired acetone to
> soften the plastic with no success.
>
> Does anyone have an effective way to remove the plastic coating from the
> fender beads? Pleas4e let me know if there is a good way to remove this
> plastic.
> Best regards,
> Tom
>
> ** triumphs@autox.team.net **
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/triumphs/wbeech@flash.net
>
> ** triumphs@autox.team.net **
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/triumphs/yellowtr@adelphia.net
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|