Perhaps the doors are from a different tub. You might just have to open or
slot the holes in the door and/or b-pillar. Whatever is necessary. I think the
striker side has a caged threaded plate in the b-pillar and it may be to it's
limit, so that is more difficult to address.
Dave H.
> On 07/22/2020 7:44 AM John Deluca <john-marie@sbcglobal.net> wrote:
>
>
> Listers,
> In final assembly of my TR2 that was partially restored by the PO. The doors
> fit well, but the latches donâ??t line up with the striker plates. Both
> latches are too high to nest in the striker plate. The latch hits above the
> striker plate opening. Iâ??ve used all the available play in both pieces and
> made slight adjustments to the doors. Iâ??m at a dead end. Any suggestions
> will be appreciated.
> John DeLuca
>
> Sent from my iPad
> ** triumphs@autox.team.net **
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/triumphs/dlhogye@comcast.net
** triumphs@autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/mharc@autox.team.net
|