Hi Bob,
Using two .005â?? oversized thrust washers in your situation will result in
.001â?? clearance. Use one standard and one .005 and that would get you down to
.006. I think that is closer to the maximum tolerance though. It will be
interesting to see what others think l
Dave Connitt
Sent from my iPhone
> On Dec 4, 2020, at 4:24 PM, Bob Nogueira <nogera@hotmail.com> wrote:
>
> Catologs show that thrust washers are available in Standard and .005
> oversized.
> Since the washers act in both directions, front to back back to front, does a
> .005 set reduce total clearance .010?
> With standard size I currently have a bit more than .011 play. Will using a
> set of .005 washers, will the play be reduced to .006 or .001?
> Thank you
>
>
> Bob Nogueira
> ** triumphs@autox.team.net **
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/triumphs/dconnitt@fuse.net
** triumphs@autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/mharc@autox.team.net
|