From morgans-bounces@autox.team.net  Wed Jul 11 18:45:31 2007
From: deemi@juno.com
To: morgans@autox.team.net
Date: Wed, 11 Jul 2007 20:42:28 -0400
Subject: [Morgans] Timing with Webers TR4 engine

I am hoping for information on what others know or use with Weber carbs
on morgans
 
i am running my super sports with a D cam and  42 DCOE Webers.
 
on webers there was no advance, and am trying to double check my timing
and the experience others have in running such setups.
 
any clues, references or experience is very much appreciate, These things
are not out there in many publications!
 
My timing slipped and the distributor was loose so my fault but wanted to
hear what else people used before
 
 
Thanks very much in advance.
 
Bob Bowie in Maine
_______________________________________________
Morgans mailing list
Morgans@autox.team.net
http://autox.team.net/mailman/listinfo/morgans

From morgans-bounces@autox.team.net  Wed Jul 11 19:28:50 2007
From: Stephen D Stierman <morgan7709@sbcglobal.net>
To: deemi@juno.com, morgans@autox.team.net
Date: Wed, 11 Jul 2007 18:28:27 -0700 (PDT)
Subject: Re: [Morgans] Timing with Webers TR4 engine

Hi Bob,
The Pub Crawl guys stop to see you yet?  Gary Kneisely
has been sending back daily reports........

About your timing, set it to what the book calls for,
I show 4 degrees befor TDC, assume you know how to do
that timing light or test lamp, drive it and see if it
pings under light load when you stick your foot in it,
if not advance a couple more degrees, find the point
where it just pings and set it back just a tad.  This
is not rocket science.
The weber carbs have nothing to do with timing. 
Compression, octane, and air temp are the factors.  If
you run higher octane fuel, you can dial in a little
more advance.  You are at the proper point using what
you have if you set it just so it starts to ping.  You
can listen to all the bs from the 'experts' but this
is the optimum set up.  Your lack of vacuum advance is
not an issue, but make sure the centrifical advance
weights in the distributor are free to move. 
Steve Stierman, Plus 8, R7082
--- deemi@juno.com wrote:

> I am hoping for information on what others know or
> use with Weber carbs
> on morgans
>  
> i am running my super sports with a D cam and  42
> DCOE Webers.
>  
> on webers there was no advance, and am trying to
> double check my timing
> and the experience others have in running such
> setups.
>  
> any clues, references or experience is very much
> appreciate, These things
> are not out there in many publications!
>  
> My timing slipped and the distributor was loose so
> my fault but wanted to
> hear what else people used before
>  
>  
> Thanks very much in advance.
>  
> Bob Bowie in Maine
> _______________________________________________
> morgan7709@sbcglobal.net
> Morgans mailing list
> Morgans@autox.team.net
> http://autox.team.net/mailman/listinfo/morgans
_______________________________________________
Morgans mailing list
Morgans@autox.team.net
http://autox.team.net/mailman/listinfo/morgans