[6pack] Engine Build

[Raymond Hatfield]

Hi Everyone,

I'm in the planning stages of my engine build and have a few questions.  first
of all, here's what I intend to do so far:

*  Shave head to bring compression to 9:1, port and polish
*  Zero-deck the block (remove recesses in block and user earlier head gasket)
*  bore block for cam bearings
*  lighten and balance rotating parts
*  TR 5 camshaft
*  Goodparts 1.65:1 roller rockers
*  Megasquirt contolling multi-port injection 
  (hope to get a set of PI plenums, else fab my own) and EDIS ignition system
*  Lighten flywheel
*  Alternator conversion
*  High-torque starter

First question:  This will be a street engine, does anyone see anything I
should do differently from above?

Second question:  The engine I have came without a distributor (hence the EDIS)
so is there anything special I need to do about the oil pump/distributor drive
other than fabricate a plate for the distributor mounting hole?

Thanks in advance,
Raymond L. Hatfield



      ____________________________________________________________________________________
You rock. That's why Blockbuster's offering you one month of Blockbuster Total Access, No Cost.  
http://tc.deals.yahoo.com/tc/blockbuster/text5.com