[6pack] heater valve control cable

[Bob Danielson]

If you're talking about the cable that connects to the heater control valve
at the engine, there's a clamp that holds the outer cover in place so the
inner wire can move. If you need a picture, let me know.


Bob Danielson
1975 TR6 CF38503U
Running w/ Throttle Body Injection
Toyota 5 Speed & Nissan LSD
http://tr6.danielsonfamily.org 

-----Original Message-----
From: 6pack-bounces at autox.team.net [mailto:6pack-bounces at autox.team.net] On
Behalf Of acekraut11 at aol.com
Sent: Sunday, November 02, 2008 1:09 PM
To: rpeglow at optonline.net; 6pack at autox.team.net
Subject: Re: [6pack] heater valve control cable

 Bob,

The outer sheath has a clamp that is held by a screw under the dash.? You
should be able to look under the dash on the drivers side above the gearbox
hump and see right where the clamp is.

Aaron


 


Aaron Cropley
71 TR6 (Throttle Body Injection!)
http://www.triumphowners.com/108
2002 Mini Cooper S
Topsham, Maine

 


 

-----Original Message-----
From: Bob <rpeglow at optonline.net>
To: 6pack at autox.team.net
Sent: Sun, 2 Nov 2008 3:07 pm
Subject: [6pack] heater valve control cable










Hello,
Heater control cable hardly moves center wire at heat control valve.
Dashboard end moves properly, so it seems the outer sheath has come  loose
on control side. Is there something that comes loose and can be tightened or
is this the way these cables usually fail? Thank you and regards, Bob
6pack at autox.team.net
http://autox.team.net/mailman/listinfo/6pack

http://www.team.net/archive

You are subscribed as 75tr6 at tr6.danielsonfamily.org