[6pack] Throw Out Bearing Question

[Lfm614 at aol.com]

I am going back together and ready to put the tranny on the motor.  I  bought 
a brand new standard OEM throw out bearing assembly from TRF to  replace my 
old one that was starting to sing.  The new sleeve does not  have the pin to 
keep it from turning on the fork pins like the  old one, it has the little hole 
though.  How critical is that pin?   Doesn't look like you can get one in 
there once the sleeve and bearing are  pressed together. I did notice that my old 
one has two notches or impressions  from the old pins up against where the pin 
is and 180 deg out.  I thought  that maybe that is the reason the pin may 
longer be used.
 
Any experience with this?  Is this assembly put together wrong?
 
Thanks,
 
Lou
 
 
**************Feeling the pinch at the grocery store?  Make meals for Under 
$10. (http://food.aol.com/frugal-feasts?ncid=emlcntusfood00000002)