[6pack] Choke Cable

[Glenn Franco]

With the recent thread on the 6 pack email list, I have a couple of 
questions for the wisdom of the collective groups.
Just installed a triple stromberg (Good setup) on a rebuilt early TR6 
engine with a cam this past fall. The only problem I have is during 
starting, it takes more than two carbs to start the beast. I need a 
third cable to connect to the center carb to get it going. after that it 
runs to problem.
Any one else had this issue? I have the front and rear carbs on the 
cable. The center carb is not contributing to the starting event.
All three carbs were extensively rebuilt including throttle shafts and 
seals.
Any ideas out there??
Thanks in advance
Glenn Franco
3 TR6's , TR250, Spit race car and a nice 76 rust free spit.