[6pack] Final Throws

[David Fidler]

Dwayne,

It will NOT slide. The only way to get it in is to put it in position, tuck
the back edge of T into the channel in the center of the header rail and,
using a flat blade screwdriver slowly work your way out to the end pushing the
front edge of the T into the slot. Then go out to the other end. This will
take about 45 mins all told, and you'll need patience.

I wrote a 2 part article about installing soft tops in 6-PACK magazine, this
step is described in part two in the summer 2010 issue, which is available in
the member's area at www.6-PACK.org.

Best regards,

David.

Sent from my iPhone

On Nov 7, 2011, at 8:27 PM, Dwayne Cooper <dc_bruin at hotmail.com> wrote:

> I've just about finished my soft top install and so far I'm pleased with
the
> results.  My last little hurdle is installing the weather stripping across
the
> front.  I was planning just to slide it in from one end and feed it through
> the three channel parts, but it's way too tight for that.  Does anyone have
a
> trick for installing this piece that they could share?
>
> Thanks,
>
> Dwayne
>
> ________________________________________
>
> 6pack at autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
http://autox.team.net/mailman/options/6pack/djfidler@rogers.com