[6pack] heater control valve

[Greg Lemon]

Mr. Sloane did a pretty good job of describing it, but as they say, a 
picture is worth a thousand words: 
http://www.victoriabritish.com/icatalog/tc/full.aspx?Page=79  items 9 and 
10, don't think your castellated nut was part of the set up, it must have 
fallen off something else.  Greg Lemon

--------------------------------------------------
From: "im sloane" <im_sloane at hotmail.com>
Sent: Friday, November 22, 2013 5:45 AM
To: "Dave" <dave at ranteer.com>; "Triumph 6 Pack" <6pack at autox.team.net>
Subject: Re: [6pack] heater control valve

> It's a little thingie with a hole thru it on the side, threaded inside, 
> and a
> small bolt goes into the end, tightening up on the control wire. When the 
> wire
> is out, nothing holds it into the valve lever.
> good luck.Sloane :)69 Six, 72 Spit
>
>> From: dave at ranteer.com
>> To: 6pack at autox.team.net
>> Date: Thu, 21 Nov 2013 22:29:53 -0600
>> Subject: [6pack] heater control valve
>>
>> was replacing the heater control valve (72 TR6) tonight, and ok  - I will
>> admit it b I wasnbt paying close enough attention.
>>
>> apparently the little bolt/nut combination just drop right out when you
>> arenbt looking.  I found a castle nut on the floor that looks the right
> size
>> b is that part of it?  and what I will hope to find in the morning is a
> bolt
>> with a hole in it?  that the wire goes through?  a picture would be 
>> really
>> helpful.
>
> ________________________________________
>
> 6pack at autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: http://autox.team.net/mailman/options/6pack/glemon@neb.rr.com