[Alpines] AutoPower roll bar clearance

[Ramon Spontelli]

Ugly only if you leave 'em off.

For us, it just complicates the procedure.  Take the side panels off, raise
the soft top, put the side panels back on.  Then take the side panels off,
lower the soft top, put the side panels back on.

But wait!  That is ugly . . . But is not impossible.

Ramon


-----Original Message-----
From: jarrid_gross at earthlink.net [mailto:jarrid_gross at earthlink.net] 
Sent: Wednesday, November 18, 2009 7:53 PM
To: rspontelli at earthlink.net; alpines at autox.team.net
Subject: Re: [Alpines] AutoPower roll bar clearance


Yeah I was mentioning that you cant get the panels open with the bar in
place.
Remove the door and its a non issue.

Ugly, but a non issue.

Jarrid


-----Original Message-----
>From: Ramon Spontelli <rspontelli at earthlink.net>
>Sent: Nov 18, 2009 5:58 PM
>To: alpines at autox.team.net
>Subject: Re: [Alpines] AutoPower roll bar clearance
>
><< You have zero chance of getting the soft top out of the top cover panels
>though.>>
>
>It might not be quite that bad Jarrid.
>
>We've never had a soft top on the Series II, so I can't say for sure, but
on
>our Mk I Tiger we can get the soft top up and down by completely removing
>the two side pieces of the enclosure.  Yeah, it's a pain, but it can be
>done, at least on the Mk I Tiger.  Is there some reason it couldn't be done
>on the Series II?  
>
>Ramon
>_______________________________________________
>Support Team.Net  http://www.team.net/donate.html
>
>Alpines at autox.team.net
>http://autox.team.net/mailman/listinfo/alpines
>
>http://www.team.net/archive